Description
Stedox Wall Brace | Support 23 | 6.4 to 11.1 ft
The Stedox Support 23 is an adjustable steel wall brace used to hold tilt-up panels, precast elements, timber frame walls and formwork plumb while they are set and connected. It reaches from 6.4 ft out to 11.1 ft, so one brace covers walls up to about 10 ft with the floor bracket set back at a working angle.
Adjustment is made by turning the brace rather than nailing off lumber, and two locking pins take up the coarse distance first. The tube is hot dip galvanized and then powder coated, and the forged threaded rod runs as one piece through the load path with a built in stop so the thread cannot run out on site.
Each Brace Includes the Following Items:
- 1 - Stedox Support 23 Wall Brace (STEDOX23)
- 1 - Operating Instructions and Load Table
Specifications:
- Length: 6.4 to 11.1 ft
- Weight: 29.1 lbs
- Rough Adjustment: 3.94"
- Locking Pins: 2
- Bracing Angle: 30 to 60 degrees
- Allowable Load: 2,700 lbf, easing to 2,380 lbf at 11.2 ft
- Finish: Hot Dip Galvanized, Powder Coat Yellow
- Origin: Made in Finland
- Shipping Dimensions: 78" L x 6" W x 6" H
Allowable Load by Length:
- 6.6 ft - 2,700 lbf
- 8.2 ft - 2,700 lbf
- 9.8 ft - 2,700 lbf
- 11.2 ft - 2,380 lbf
Allowable loads include a safety factor of 1.5 and are based on Eurocode 3 calculation and laboratory testing. Final loads should be confirmed by a qualified engineer for your own wall height, wind exposure and bracket position.
At Southwest Scaffolding, we are committed to your safety and providing the highest quality equipment for your masonry needs.
